Tuesday, December 4, 2012

Mock-Up: Radiator (November 14, 2012)


Today we received the Entropy radiator module.  Installation was pretty straight forward.  There are 2 brackets, 1 for each side that bolt to the original radiator mounting holes in the core support.  







The cut-out portion of the core support is for a future project, cold air intake box.  




Mock-Up: Fuel Pump Control Mount (November 11, 2012)


This will be a mount for the Vapor Worx PWM fuel pump control system.  It will be located in the trunk on the driver's side, just forward of the hinge support.  This seems to be a good location, as it's close to the fuel pump and the battery, which is trunk mounted. There are 3 components, the PWM module, fuel pressure signal conditioner and a fuse.  Other than initial setup, there should be no reason to need to access this.  

I started with a poster board mock-up then transferred it to a piece of 16 ga. steel.  









Test fit






Welded in place




Primed