This will cover the cabin side of the EFI harness mods. The ECM and relay/fuse box will mount under the dash. Mounts were fabricated during mock up.
Began with the ECM mounted, connected the connectors to layout a path for the harness.
This is the harness with the convoluted tubing removed.
Started tidying up from the fuse box end.
Test fit
This will be the other half of the bulkhead connection.
Back to the bench for more trimming and tying up.
And another test fit....
DBW pedal connection
Ready for wrap. Much cleaner than where it started.
Finished harness
Made this bracket to support the harness near the 3 ECM plugs. It will screw into the hole that held in the factory front speaker.
Keeps everything clear of the wiper rod.
There will be an adele clamp to hold the lead to the pedal.
All that is left is to crimp the pins to the wires for the bulkhead connectors. Crimping tool is on it's way.
No comments:
Post a Comment