I won't go into a lot of detail on this, just basic audio wiring.
I put the RCA's in some power braid along with the amp turn on wire.
Starts up front the goes across the dash to the passenger kick panel area.
Then down through a hole into the channel along the door sill area.
To the rear - I slipped some aluminized DEI sleeve over the power braid where it runs across the battery cables to act as an EMI shield as not to pick up any noise from the charging circuit.
Then up to the amp. This side is the power and speaker connection points.
This side is the RCA pre-amp connections.
Just a test of the front driver's. They will be mounted in the kick panels by the upholstery shop.
No comments:
Post a Comment