More miscellaneous wiring pics.
This is the Phantom ignition pushbutton. I used an aluminum washer that I polished, as the hole in the bezel was too big for the button.
Phantom wiring all tied up.
ECM wiring all tied up.
This is the relay connector for the DSE wiper harness.
More Phantom shots
The bundle hanging down is the various sensor leads for the VHX dash.
Column test fit for harness clearance.
Made this small shield to protect the harness from the top of the clutch pedal.
Here you can see the clutch safety switch.
This is a Metri-pack connector for the leads going to the trunk. It will be located in the driver's side kick panel.
The mess is getting smaller!
No comments:
Post a Comment